ABA DSS - Free to Air Satellite TV Community - View Single Post

scubagirl · September 15th, 2009

I am running Nfusion Phoenix
one dish 500 dish with DP twin (internal switch)
one Dish 500 with DP single LNB
1 DP34 switch
2 receivers so far going for 4 hopefully
less than 150 ft of cable to each receiver
new cables run all rg 6
Dishpro twin, one cable to port 1, one to port 2
Dishpro single to port three

settings

110 echostar
LNB : Twin DPLNFB
LO freq 11250
22 khz off
Diseqc 1.0 port 2
dis 1.1 disable
Multi dish switch:disable
Lock tp:12224
LNB power on

119
LNB: Twin DPlnfb
Lo Freq 11250
22 khz: off
Disesqc :1.0> Port 1
lock tp 12239
lnb power on

91
dp sinlge
Lo freq 11250
22 khz off
diesqc 1.0 port 3
lnb power on

This was running fine initially then I would be in the middle of watching and the signal would be lost to all three satellites on two receivers, tried rebooting by back switches, this worked at times and not others then after quite a few hours it would work again all signals would be back all signals between 74 and 78 and quality 83-88.

All lnbs work when connected separately to each receiver and the internal switch in the DP twin works fine when not connected through the dp34 switch. Is this a bad DP 34 switch do you think? It was brand new and does work from time to time. Any other suggestions to try?

September 15th, 2009	#1 (permalink)
scubagirl Knows FTA Join Date: Apr 2007 Location: Texas by way of Ontario Posts: 100 Credits: 1,203.65 Thanks: 33 Thanked 39 Times in 23 Posts	Hard time with new set up I am running Nfusion Phoenix one dish 500 dish with DP twin (internal switch) one Dish 500 with DP single LNB 1 DP34 switch 2 receivers so far going for 4 hopefully less than 150 ft of cable to each receiver new cables run all rg 6 Dishpro twin, one cable to port 1, one to port 2 Dishpro single to port three settings 110 echostar LNB : Twin DPLNFB LO freq 11250 22 khz off Diseqc 1.0 port 2 dis 1.1 disable Multi dish switch:disable Lock tp:12224 LNB power on 119 LNB: Twin DPlnfb Lo Freq 11250 22 khz: off Disesqc :1.0> Port 1 lock tp 12239 lnb power on 91 dp sinlge Lo freq 11250 22 khz off diesqc 1.0 port 3 lnb power on This was running fine initially then I would be in the middle of watching and the signal would be lost to all three satellites on two receivers, tried rebooting by back switches, this worked at times and not others then after quite a few hours it would work again all signals would be back all signals between 74 and 78 and quality 83-88. All lnbs work when connected separately to each receiver and the internal switch in the DP twin works fine when not connected through the dp34 switch. Is this a bad DP 34 switch do you think? It was brand new and does work from time to time. Any other suggestions to try?