No Indian channels with the new fix of Viewsat Ultra V2

[emahou]

All,

I need help here. I have 110. 118.7 and 119 channels with Viewsat Ultra V2. I was getting the indian channels, but do not get anything now since I loaded the new file. I just get Auto Roll processing for all the indian channels. Please advise what has to be done...

[DishCharlie]

I have seen extended autoroll times on the International channels. Try Ch200 CNN until the update occurs, then switch back to 118.7W.

[ka1300]

DishCharlie,

Ch 200 CNN works just fine...I switched to the 118.8 channels and nothing comes...Just Autoroll processing for 1 hour now...

[DishCharlie]

That is puzzling as the A/R update should be valid for all channels received. I have been able to awaken my SV4000 by the CNN method. I will look around to see if others are having similar problems with the VS.

[DishCharlie]

I have come across several posts indicating continuous A/R only on some channels of the VS Ultra. One Moderator solved the problem by resetting the VS to Factory Default and rescanning the sats.

[ka1300]

Dishcharlie,

Shoudl I just upload the factory settings, enter the antenna settings again and upload the new fix?

[just4ufolks]

Like indicated in the lpreceeding post - RESCAN the relevent SAT and reload the current working file...gud luk it has helped others with similar situations..

[ka1300]

Ok I will do that...In that case is this the procedure to follow?

1. Load factory file.
2. Enter antenna settings
3. Upload the latest fix

The reason I am asking is because this is the first time I am doing this. Just set it up last week with the help of installer.

[just4ufolks]

Originally Posted by ka1300

Dishcharlie,

Shoudl I just upload the factory settings, enter the antenna settings again and upload the new fix?

yes if you will do the factory reset(default0 then you will need to reset your antena settings as well F/D will erase all your setings..ensure you write down or remmember the relevent settings for the desired SAT that you are pointed at.. dl the current working file -reboot n sud b gud 2 go..enjoy..gud luk..

[jig0607]

i reebooted couple of times and its working smooth now, i am using coolsat

[ka1300]

No Luck still. I did the factory default. Entered antenna settings and rescanned. All channels come through except 118.8W channels...Its Auto Roll Processing for 45mins now. Below are my antenna settings:

Satellite: Anik F3, 118.W
LNB Power : On
LNB Type: OCS-DP
LNB Freq: 10600
22 KHZ : On
Tp Freq:11715
DisEqC:; Port 3
Motor: Off
Leagacy SW : None

Below is my 119 Settings:


LNB Power : On
LNB Type: OCS-DP
LNB Freq: 11250
22 KHZ : On
Tp Freq:12224
DisEqC:; Port 1
Motor: Off
Leagacy SW : None

Below is my 110W settings:

LNB Power : On
LNB Type: OCS-DP
LNB Freq: 11250
22 KHZ : On
Tp Freq:12224
DisEqC:; Port 2
Motor: Off
Leagacy SW : None

The lnb I have is similar to : http://cgi.ebay.com/DISH-NETWORK-500...QQcmdZViewItem

Please help me I have been trying this since morning.