Unable to get Indian channels please helppppppppppppppp

[newb9]

Area: Bay Area

Hi guys,

I am new to this FTA programming and I am trying to get some indian programming to work.
I have a superdish, installed by dn and connecting cable from superdish directly to Sonicview premier receiver without a Diseqc switch. I am able to get all the programming for Sat 110 & 119 but not for 61.5. I used to get indian programming with same dish from dn.
Where did I goof up


My Echostar3 @ the following settings:

Echo3(61.5w)
lnbpower - on
lnbfreq - 11250
lnbtype - ocs-dp
22khz - off
Diseqc - port3
tpfreq - 12326

These setting work currently:

Echo7(119w)
lnbpower - on
lnbfreq - 11250
lnbtype - ocs-dp
22khz - off
Diseqc - port1
tpfreq - 12239

Echo8(110w)
lnbpower - on
lnbfreq - 11250
lnbtype - ocs-dp
22khz - off
Diseqc - port2
tpfreq - 12224

[VGiddy]

1. Your dish settings are fine for 119 and 110 since the OCS dp LNB has an internal DiSEqC switch for Port 1 and 2. If you need to get 61.5, you have no DiSEqC switch for you to use Port 3 for it. You will need a Ecoda 22KHz switch or a SW21 switch, connect the cable from the OCS ds LNB to SW21 Dish1 and 61.5 to SW21 dish2 and your setting will also have to include for 119 & 110 - Legacy switch SW21 dish1 and for the 61.5 only Legacy switch - SW21 Dish2. If you use the Ecoda switch, then instead of using the Leacy switching item for 119 and 110 set 22kHz to OFF and for 61.5 to ON.

2. At the moment you will not be able to get any Indian or Asian Channels on 61.5 as they have been moved to Nag3. So you will have to wait till that part of the system has been rectified by the FTA Teams.

[wayne5222]

U need a 2nd dish as 61.5 is almost 90 degrees from 119 & 110. cannot get all 3 from 1 dish setup

[newb9]

I just checked my dish, I have 2.
One is dish 1000 and other is dish plus but there is only one cable we get from both of these