110 or 119

[Motothrasher]

I currently have echostar 7 119 working on my vs pro I'm recieving good signal and quality also recieving all channels available for 119! the issue is that I can do the same for 110 but in each instance I only can run one lnb at a time when I hook up into the spliter I recieve no signal. I know the spliter works because I've hooked it up on a diff dish 500 and it worked! My settings are as follows

echo7(119)
lnbpower - on
lnbtype - standart(ocs-dp with DN DISH)
lnbfreqc - 11250
DisEqc - port1
tpfreq - 12239

echo8(110)
lnbpower - on
lnbtype - standart(ocs-dp with DN DISH)
lnbfreqc - 11250
DisEqc - port2
tpfreq - 12224

Why can I not have both sats working at the same time is there a step im missing, (channel scan, auto scan, blind scan, etc........)

[cisco123]

what kind of lnbs do ya have

[gibahca]

Are using DisEqc switch?

[producerman]

If you are using a disecq switch which I assume you are you can go into antenna settings and push F1 (auto disecq ) it will detect your settings.

Producerman

BTW - dont mind my spelling.


Hope this helps

[Motothrasher]

I have no idea what lnbs im using!! I'm using Viewsat sw-41 4 in 1 DISqC switch. I'll climb back on my roof tm and set it up again and try those setting

Thank you guys,

[Motothrasher]

****!! I had some free time put 119 into lnb 1 and 110 into lnb 2 i had 80% signal and quality on 119 before i put the DISEqC Switch on droped down to zero on both. I went into settings and set the DISEqC for auto and nothing happend!! I did set up the TP and DISEqC ports on the box but still no signal or quality

[gibahca]

Try setup DisEqc none
and legacy set to sw41 dish1 . ....