Radio Channels only

[mnjroth]

Hi everyone, newbie here. I am not too sure but could you point me in a direction to go. When i do the channel scan for 110 and 119 I am only picking up radio channels. I have no tv channels at all. Any advice for me? I am not too sure where to go from here.

thanks

[cisco123]

hello and welcome to aba
need to list your settings and what dish and lnbs you have?

[boboisno1]

Are you scanning for all channels not just fta channels?

[gibahca]

On autoscan make sure you have select ALL TV&RADIO for searchType.

[mnjroth]

my lnb freq is at 11250 (both 110 & 119)

22 khz - off for both

tp freq is 11239 for 119 and 12224 for 110

diseqc 1.0 - port 1 (119) port 2 (110)

i have a viewsat vs pro receiver and a dual lnb elipticall dish. I do not know the type of lnb's since it does not say on them

[gibahca]

okay.Try to do like this.
Factory reset(menu--user settings--reset default)
Setup your antenna again
echo7(119)
lnbpower - on
lnbfreq - 11250
22khz - off
DisEqc - port1
TPfreq - 12239(Check if you have good Quality and if the satname[echo7 119w] shows up on the top right corner)

echo10,11(110)
lnbpower - on
lnbfreq - 11250
22khz - off
DisEqc - port2
TPfreq - 12224(Check if you have good Quality and if the satname[echo10,11 110w] shows up on the top right corner)

If everything appears like i said exit and save.
hit menu again,installation,autoscan.
Select the sat(119,110) and select ALL tv&radio on search type.
start the autoscan after that.

[mnjroth]

great i will try it right now

[mnjroth]

the top right corner shows antenna setting [amc 6/c72.0w] when i put it on both 110 & 119

[gibahca]

So you're hiting the wrong sat buddy.
Check your dish position with www.dishpointer.com
Use your zipcode/address and select multi-lnb's(119,110) and it'll give to you the right direction to your dish.

Ps;you'll move your dish to the right(looking from behind the dish)