Problem with v721

[vtoskov]

Originally Posted by bwillie26

Here are my settings ..

EchoStar 8/10

Switch: DiSEqC 4PORTS
DiSEqC Input: Port 2***
LNB Frequency: 11250
SID Search: Enable
TP Frequency: 12224 (V) 20000
22kHz Tone: Disable
Network Search: Disable
Search Type: All
Legacy SW: Off

Echostar 7

Switch: DiSEqC 4PORTS
DiSEqC Input: Port 2***
LNB Frequency: 11250
SID Search: Enable
TP Frequency: 12399 (V) 20000
22kHz Tone: Disable
Network Search: Disable
Search Type: All
Legacy SW: Off

what kind of dish and LNB you have?
Are you using a 4 Ports Diseq switch?
In which Port is 110W plugged and in which Port is 119W plugged?
You can't have both LNB on the same Diseq Port something is wrong with that setting.

[arboristman]

ok based on those settings you told the unit your using a 4x1 diseqc.
so you have 2 separate lnbs?
and your ports cant both be plugged into port 2.

[arboristman]

do you have one of these plugged in outside connecting 2 lnbs?



are you pointed at dishnet usa? or bev Canada?

[arboristman]

do you just a have dish 500 with one of these lnbs on it with no switches buddy?
here is whats most common:

[bwillie26]

Oddly, I know this should not be working with both 110 and 119 plugged into the same port, but I do remember this is how it was setup last time and worked perfectly until today. Could that be the culprit?

Most of which you are asking about my DISH (type of dish, lnb and all that) is something I could not tell you right off the bat, unless I go outside. Seeing as how I'm in the middle of a snow storm, I don't think I can check that right now. lol

The only thing I do know is that I am using a Diseqc 4 port switch, I know that for a fact.

[bwillie26]

Originally Posted by arboristman

do you just a have dish 500 with one of these lnbs on it with no switches buddy?
here is whats most common:

Ah, pictures. They can save me alot of time. haha

But no, mine does not look like that. I'm guessing now I am using an older dish?

[vtoskov]

Ok you are probably using a 2 Single LNB's like this one on then you run a cable from each to the diseq switch.


Something is wrong with the Diseq Settings and we need to know what is plugged into which port.
Are you sure that your dish is aimed at 119W and 110W and not Bev(82/91) or something else?

[bwillie26]

Originally Posted by vtoskov

Ok you are probably using a 2 Single LNB's like this one on then you run a cable from each to the diseq switch.


Something is wrong with the Diseq Settings and we need to know what is plugged into which port.
Are you sure that your dish is aimed at 119W and 110W and not Bev(82/91) or something else?

Positive.

I never watch any of the BEV channels, so I don't adjust my satellite towards them. This was working fine today before the freezing began. All the channels from both 110/119 were picking up fine.

[vtoskov]

well we still don't know which LNB is plugged in to which diseq port, can you at least report that?
Is 119W plgged into Port, is 110W plugged into port2?
You can't have both LNBs plugged into the same port.

After you do a factory default, all the setting are return to default state that's why they need to be adjusted.