Need help no tv - ABA DSS

**robert123** · July 4th, 2008

Im not getting any tv. Both signal and quality is very good. My problem began since installing the 1211 pvr factory and installing new 9273 pvr bin. I have tried every thing and still nothing. I am currently using a dish 1000.2 connected to 119,110 & 129 and have an illuminati board. My box was working perfectly fine up until I installed the new bins for the esata feature.

Should I worry if the new factory bin could have damaged the 8spk module or are the new bins not working at this time.

At this point any suggestions would be greatly appreciated.

**hazwis** · July 4th, 2008

when you install the factory file i believe that your settings are reset to the factory settings also. double check your antenna settings and make sure you have autoroll on. also make sure that the 8psk module is still enabled.

**arboristman** · July 5th, 2008

well.to be blunt.as i always am about pansat,so others know about them,be prepared to get out the bug spray while they work on pvr.

**robert123** · July 5th, 2008

Yeah arbor! I understand what you mean. Going on day 3 and still no tv. I have tried everything from under the sun trying to get it to work. For the first time I am beginning to having buyer's remorse buying this box. I should have listened to you and should have gotten the SV8000 instead.

How can I can verify if the 8psk is enabled?

I hope i can get this box to work soon!!!!!!!!!!

**robert123** · July 6th, 2008

I am going on 5 days now and still haven't fixed it! I did a factory reset multiple times and allowed an auto roll few hours later on channel 101. I double checked all settings and did every scan the box has to offer and picking up all channels. I even reloaded factory 1211 bin and and re installed 9273 bin. All auto roll keys are on but going to the keys, they were not updated so I manually did it myself and still getting scrambled channels. I did just about everything I know how to troubleshoot this box and still unsuccessful.

All my other boxes are all panny's, so I am not a newbie when it comes to getting them to work. I should have got this receiver to work by now but then again this is a new box with new dish.

Any help is greatly appreciated! Thanks