Cool sat 7100

[jm1922]

We are a brand new owner of a 7100 but I don't know how to start anythin much less download any files. I got the reciever hooked up but am stuck. does the flash drive already have the files loaded on it?
If not how do you know which files to download ?

[pchurch]

Jm1922 go to this link: http://www.abadss.com/forum/870-cool...ash-drive.html

But you have to upgrade your membership to download file.

[cdo_care]

First OFF Welcome to ABAdss....... In the CS7100 Help section in sticky thread there is a Guide...

[jm1922]

please help we are so confused on how to download and what files for download on the flash drive !

[bigevil69]

welcome aboard friend
everyone is willing to help you out free but
to get the most out of this site you need to upgrade your membership to vip
you can do that by clicking the payment link in my signature

How to Properly Load a Coolsat 7100 with a USB flash Drive
NOTE
ALWAYS Unplug your receiver BEFORE disconnecting Or Connecting your Coax cable Or RCA cables !! FAILURE to do so WILL damage your receiver !



1) Download and unzip both the latest release

NOTE: ALL NorW bins and or Factory bins Must NOT be in a Zip file or any other file when put onto your flash drive !

2) Put your flash drive in the USB port on your computer right click on both files and then
select (Send To) on the dropdown list. Select (removable Disk) and click on it. The files should now be on your coolsat flash drive

3) With your receiver already turned on plug your coolsat flash drive into the USB port on the back of your coolsat 7100 receiver.

4) The software Update screen will pop up on your TV. with your remote select the Coolsat_7100_Fac_Vo116 file then click the RED button above the UP button on your remote.and then the OK button.
When it is finished loading your receiver will reboot and then go into standby mode.
Remove your USB flash Drive

5) Click the Red button on the top of remote to turn receiver On and click Menu on your remote and then go to Installation screen and select System Recovery and select System restore to Factory default when the factory reset is finished set the Language of choice and then set your time zone. After setting the time zone the receiver will ask if you want to Auto detect your satellites and switch settings. Say NO at this time !

6)When your receiver reboots into standby mode or shows ---- Click the Red button on the top of remote to turn receiver On. Once the receiver is On Put your USB flash drive back in your receiver and Repeat the First 5 steps to load the Coolsat7100_NorW BIN !

5b) BUT this time say YES to Auto Detect and it will auto set your LNB type and switch settings and then scan All the satellites your pointed at !


NOTE
ALWAYS Unplug your receiver BEFORE disconnecting Or Connecting your Coax cable Or RCA cables !! FAILURE to do so WILL damage your receiver !


then load norw v194