[arboristman]

c/p from Covert-Ops
How To Use A V-Box With Your Fta Reciever To Move A Polar Mount
There Has Been Some Questions On How A V-Box Works I Have Two Dishes That Have This Type Of Setup So Hope This Helps In The Explanation! Cheers ~NO1

[arboristman]

c/p
This Moteck VBoxII is used to position your C band dish. It takes DiSEqC 1.2 commands from your MPEG2 DVB satellite receiver and converts it into 36V pulse and sensor to store positions - can store 99 Positions. It can work as a stand alone positioner or it can accept DiSEqC 1.2 commands from a satellite receiver. Motor. Controls and displays position. Remote control Included.

FEATURE:
Compatible with DiSEqC 1.0 /1.2 Receiver or Any Receiver
Compatible with any Reed Switch Actuator or H-H Mount
5V DC Output for Optical Sensor Actuator ( Optional )
3 Digit LED Display
Drive Dish up to 3M
99 Satellite Positions
Fine-tune EAST / WEST Buttons
Optional Remote Control Available
Overload Protection ( Auto-recovery )
Anti-Noise Design

Remote Control Included
Specification:
Model V-BOX II
Input 110 VAC / 60Hz
Output 36 VDC
Max. Dish Diameter 3M
Max. Output Current 3.5A
Max. Power Consumption 80W
Protocol DiSEqC 1.0 / 1.2
Positions Memories 99
Controled by DiSEqC 1.2 Receiver or Optional Remote Control
Display 3 Digit LED
Resynchronize Function YES
Manual Buttons Power ON / OFF, EAST / WEST
Protection Software Limit Protection
Electric Overload Protection

these go for around $70-$90 USD.