ABA DSS - Free to Air Satellite TV Community - View Single Post

**grasshopper** · June 17th, 2007

How to hook-up the loop-out in the back of your receiver after the 8PSK Module is installed

Looking down on the 8PSK module before installing it into the receiver. Note the IEC 169-24 female (coaxial) connector sticks out through the receiver housing

Looking down on the original unmodded receiver. Note the location of the cable in the top left corner. That is the power connection cable that gets connected to the sub-board assy. You need to clip the tie wrap that holds it in place first.

June 17th, 2007	#3 (permalink)
grasshopper Super Moderator Join Date: Apr 2005 Location: Far Far Away Posts: 7,446 Thanks: 468 Thanked 16,246 Times in 2,507 Posts Rep Power: 134	How to hook-up the loop-out in the back of your receiver after the 8PSK Module is installed Looking down on the 8PSK module before installing it into the receiver. Note the IEC 169-24 female (coaxial) connector sticks out through the receiver housing Looking down on the original unmodded receiver. Note the location of the cable in the top left corner. That is the power connection cable that gets connected to the sub-board assy. You need to clip the tie wrap that holds it in place first.