I think my SV360 Elite is done - ABA DSS

**rajiv427** · May 29th, 2008

The receiver boots fine but after the booting it gives me number 1 only,nothing comes up on the TV screen.

I loaded the Factory file three time and the download was successful but after the booting,I get the same #1.Remote is not working at all.

Anybody had this problem.

Any idea or just return it.

Thank's

**cdo_care** · May 30th, 2008

Sorry rajiv427 no idea. But how is it now your 360 buddy?

**carpenter1** · May 30th, 2008

Walk up to the receiver and push the power button on the front panel or on the remote

**toe** · May 30th, 2008

my sv 360 elite did the same thng, unplugded it from the wall 4 about 1 hour, pluged it back in turned it on from back and then powered it up from front and every thing good as new!!

**toe** · May 30th, 2008

i forgot to ask u if you pluged your rca into back o rec.???

**lonster** · May 30th, 2008

You can drain the current manually. Unhook completely, lnb rca's or whatever you use. ect.

Turn the box off with the rear switch, unplug from wall, turn back on with the switch and leave on for 30 sec to a min. Turn the switch back off and plug it back in. Current is drained.

**toe** · May 30th, 2008

good point faster than letenner sit for awhile with it unpluged.

**rajiv427** · May 30th, 2008

I have tried everything guys but still the same thing.

I'm going to load the factory again otherwise I'll just return.

Thank's guys.

**toe** · May 30th, 2008

sounds like your havvin some problems, hope you fixer up dude and good luck. let us no in a bit watttzzz up with prognosis

**lonster** · May 30th, 2008

Quote:

Originally Posted by rajiv427

I have tried everything guys but still the same thing.

I'm going to load the factory again otherwise I'll just return.

Thank's guys.

Try the process I gave you but try to flash back to factory via serial upon first boot. It may help.

I hope you get it worked out.

**cdo_care** · May 30th, 2008

rajiv427, try this:;; Updating with the null modem,If that doesn't work you could try something from Premier area,Make sure you are powered OFF with the rear switch,insert the USB stick.While pressing the OK Button ON the front panel turn ON the power switch,select the upload file and off you go...