how to recover from scrolling pic(PAL mode back to NTSC)

[arboristman]

Originally Posted by bigevil69

try this:while receiver in standby mode, press RED function key + 2+5+8+0. This will swith from PAL to NTSC and reverse. This is a new function with the latest release.

Originally Posted by rajiv427

Turn your receiver Off then ON.

Press Menu.
Press Down.
Press Right.
Press Down.
Press Ok.
Press Up.
Now press right or left until it gets back to normal.

Originally Posted by bastio

There are two other simple ways to solve this:

1. While in standby (for bins V0141P and up), press on the remote the following key sequence: red, 2, 5, 8 and 0 (one at a time). The STB will internally change to the next TV standard and blink 3-4 times the new active setting on the front panel display: PALm, PALn, or ntSC. If this is not the one you want repeat the operation after the box display returns to the clock display.

2. After turning ON the STB, press on the remote, the following key sequence: yellow , up, right (one at a time). The STB will switch to the next TV standard. If the TV display is still not OK, repeat the operation to change to the next one.

I would suggest to play with these, so if and when it happens you know all about it.

.................................................. .......................................