Strange issue with channels

[asick]

I'm not using a Diseq switch, I have the DP34 switch installed, and I get both the 110 and 129 from a dish using dual LNB's. also somehow the lnb's are for 110 and 119 but I can still get some channels from 129, is that possible?!!

[mountaineer]

Sounds like a switch issue with a bad setting.

[jc7257]

If you are getting 110 and 129, I assume you have two dishes. Do what mountaineer said and see if it is the switch. If you are using a diseq switch, they will go bad pretty easily. The ones that come with the new STB's are just cheap ones. If this doesn't work, load the clean system file, Jan bin, enter Sat settings again, and scan the Sats again...

[asick]

I'm not using a Diseq switch, I have the DP34, and I get both the 110 and 129, is that possible?!!

[texas etech]

I you will notice, you are getting 119 on port 2 and 129 on port 1. So where you think you are getting 110 is most likely 119 unless you have seperate lnb's and you have an 18 degree spacing between them. You are misalligned on your dish. Off by about 9.5 degrees +/-. You are picking up Ciel 2 where you should be getting 119 and getting 119 where you should be getting 110. Easy to do. When you get a good quality signal, the name of the satellite will appear above the signal graph.

Your dish needs to turn 9 degrees to the east and raise your elevation slightly. Your skew could be off a bit as well. I have seen this many time over and sometime they are off by 9 degrees in the other direction. Put a pencil mark on your beginning on azmith and elevation as well as skew.

I don't have a dish pointed at Ciel 2 yet. I just got my BUD in the air this weekend and am waitingon parts for it and on the arrival of my pansat 31 inch with Invacom quad LNBF. Already have the motor for it. Just give me a little bit of time and I'll be getting everything that get transmitted into my airspace.