Guide Info on Bev - ABA DSS

**cr812** · September 13th, 2008

Hi Folks,

I'm running 91, 110 and 119 and getting good pics on all. However, I cannot get guide info for any of the 91 channels. I have alot of guide info on all of the DN sats, but nothing on Bev.

I have selected just the 91 sat, and let it sit on channel 400 for a while. Eventually it will populate the EPG. However, if I switch over to the DN package sat, and then go back to BEV or Nimiq, all of the EPG info on Bev goes back to "No Information"

If I select all Sats the BEV channels all get a 2 in front of it, but the epg never populates for that sats channels.

Is there something I'm missing ????

**boboisno1** · September 13th, 2008

Try ch 218 or 2218 E!ont

**gibahca** · September 13th, 2008

Okay buddy i have the same problem before selecting ALL SAT'S.
There is a problem because when you DL the EPG for both(DN and BEV)
You should leave it for 3 days only.
You can have only 3 Days EPG for BEV.
If you do both togheter like i do,setup it only for 3 days.
Give it shot and post back here.

You can have 7 days EPG if you select only DN packages.

**cr812** · September 13th, 2008

Okay, give me a few minutes and I'll see.

I do know I'm currently set at 7 days, so I'll go change it and report back......

**cr812** · September 13th, 2008

Absolute Genius.....................

Changed the guide days to 3, went to 2218 and 1 minute later evrything is populated.

Thanks guys........

You're the best!!!!!!!

Off to watch TV........

**gibahca** · September 14th, 2008

Thank you buddy.
Your reply is very important.
Enjoy your TV.

**SystemDude** · September 14th, 2008

I have a two-dish setup -- one for 119/110 and one for 91 -- feeding my 360 Elite. In my specific case I have never found it necessary to change the EPG length. But I found that I needed to sit a couple minutes on channel 50 (or 2050) to load the bev EPG.

Funny, that......

**gibahca** · September 14th, 2008

Quote:

Originally Posted by SystemDude

I have a two-dish setup -- one for 119/110 and one for 91 -- feeding my 360 Elite. In my specific case I have never found it necessary to change the EPG length. But I found that I needed to sit a couple minutes on channel 50 (or 2050) to load the bev EPG.

Funny, that......

I never wait for it because i setup my vspro to download the EPG 2:00am in stand-bye mode.
Setup to 3 days only and it works very well.
Everyday before go to bed put my receiver on stand-bye mode and my EPG is always populate.