Need help am newbie

[Jtwgdl]

Hi Everyone
I am new to this so sorry if I am posting in the wrong place, I have a Sonicview 360 premiere, I have two dishes, one pointed at 110 and one pointed at 119 I get the channels up to 417 but cant get any more, does anyone know if this is normal or do i need to do something to get the rest of the channels.

Thanks in advance

[mountaineer]

What are your antenna settings on both sats?

[bigevil69]

also are the lnbs dishpro or generic

[Jtwgdl]

I have generic single LNB's here are my satellite setings

Echostar 7
LNB type Single
LB Freq. 11250
22kHz off
LNB power on
Transponder 12224
Search Option All
Network Search on
DisEqc off
motor disable
Legacy Switch sw21lnb1

Echostar 8,x
Echostar 7
LNB type Single
LB Freq. 11250
22kHz off
LNB power on
Transponder 12224
Search Option All
Network Search on
DisEqc off
motor disable
Legacy Switch sw21lnb1

Thanks Again

[jc7257]

Change the transponder freq for 119 to 12239. I think a diseq switch would probably work better for your setup, instead of the SW-21 switch. Get a diseq switch, hook 119 sat into port 1 on diseq switch, hook 110 to port 2 on diseq switch. Hook cable up from diseq to STB. Go into sat setup, under diseq switch, define 119 to port 1, and 110 to port 2. let us know. May need to factory default. This will erase all your channels. Enter the settings I described for the diseq after you install it, and then scan the sats again...

[Jtwgdl]

Thank You so much, I will try the settings and then try to switch to diseq switch