SV 360P help...pls!

[tomtom321]

i think accidentally clicked on pvr-network download. i have all the correct files on 1.4 for the ihub and file 2.45-P but no pic. now! can someone pls. help me get the pic. back up?

thanks!

[bigevil69]

did you try a hard reboot with back switch

[tomtom321]

yes. but nothing happened i ran the wiznet and it shows that it's still running 1.4 and the version on the receiver say 2.45-p i'm stuck

[bigevil69]

go into options and make sure priorty is still set to ihub

[carpenter1]

Change DNS to NO and put this IP number in it 77.93.75.89
Also change the setting type to DHCP

[tomtom321]

it was set to both and i changed it to ihub and still nothing (it's under the user options section right?)

[carpenter1]

Originally Posted by tomtom321

it was set to both and i changed it to ihub and still nothing (it's under the user options section right?)

Did you do what I just told you?
Also put it on a working channels such as 300 and wait because it could take a few minutes to start working.

[tomtom321]

carpenter1, yes i did what you said as well and still nothing. have it on 305 now and it still says scrambled

thanks for taking the time to help with my mess

[tomtom321]

still nothing. i'm pretty sure all my settings r correct n i still got nothing...this really sucks

[carpenter1]

You won't know if that worked at this time because the server just went down.

[tomtom321]

oh great...just my luck lol. so no channels are working now?

[carpenter1]

I have it on 300 and it's working for now

[tomtom321]

i have it on 300 and nothing. what am i doing wrong? is there a way i can reset the receiver and start all over again?

[gibahca]

yep...load the latest factory file and start over.

[carpenter1]

OK when you do a hard reboot do you see that the iHub is connected on the screen?
When you check on the Wiznet does it show you your IP and does that IP differ from the one that is used by your computer?
Are both lights on in the back of the iHub (one solid and one blinking) ?
Do you see in the Menu IP Config ?
Just want to eliminate some problems that might cause this.

[tomtom321]

Originally Posted by carpenter1

OK when you do a hard reboot do you see that the iHub is connected on the screen?
When you check on the Wiznet does it show you your IP and does that IP differ from the one that is used by your computer?
Are both lights on in the back of the iHub (one solid and one blinking) ?
Do you see in the Menu IP Config ?
Just want to eliminate some problems that might cause this.

yes when i turned on the receiver it said "netwk. adapter connected" then i checked the menu and the IP Config is on
When i checked the local IP on the comp. it says .4 but on the receiver it says .6
Both lights are on in the back of the ihub (green=steady, orange=flashing slowly)
I haven't done the factory flash yet