Missing channel on my Ultralite - ABA DSS

**332** · January 6th, 2009

I have an Ultralite and an Platinum receiver fed by the same Lnb and the menu setup is similar for both receivers. I am not able to make my Ultralite receiver to receive channel 136 on satellite 110. What could be the problem.

**badsrt45** · January 6th, 2009

what type of setup do you have? what lnb please post your antenna settings. what sats are u trying to get?

**bigevil69** · January 7th, 2009

badsrt is right we need a little more info

**332** · January 7th, 2009

Thanks for your replies.
I am using A Dish net dual LNB dish. My antenna is set to receive a signal from the 119 and 110 satellites in my setup. The lnb is set to "standard" for both the satellite. The missing 136 channel is occurring with the Ultralite receiver.

**badsrt45** · January 7th, 2009

Quote:

Originally Posted by 332

Thanks for your replies.
I am using A Dish net dual LNB dish. My antenna is set to receive a signal from the 119 and 110 satellites in my setup. The lnb is set to "standard" for both the satellite. The missing 136 channel is occurring with the Ultralite receiver.

with you having a dish net dual lnb dish your LNB should be set to OCS-DP for both satellites and you should not have a switch hooked up. the lnb has a built in switch and your diseqc setting should be port 1 for 119 and port 2 for 110. delete your channel list and rescan with new settings. you should have all your channels then. post back and let us know results.

**332** · January 7th, 2009

Thanks.
I followed your instructions as written but still no 136.
I received the channels listed as follows; 119,126,133,141,and so forth.
My Platinum receiver doesn't miss any channels.
I corrected the writing in this message.

**badsrt45** · January 7th, 2009

do a hard reboot of the ultra lite reciever by switching it off from the back and wait about 3min and turn it back on and let us know

**bigevil69** · January 7th, 2009

load this sat file and follow direceions and see if that helps

http://www.abadss.com/forum/969-view...info-u00b.html

**332** · January 7th, 2009

Thanks.
Followed your instruction, but no change in the last order of channel listing.
I loaded the sat file in my receiver, cold booted for 3 minute and did a factory default.
Did an "auto scan" which loaded the channels proper in order up to channel 219, but when I used the guide they showed about the same, with the missing channels, 136 was still missing.