dish network

[bbeals]

Why do I have Bev 91 all channels with bin #204 and dish still says scrameld I have reinstalled 204 and tried turning switch off at back twice still no go.Iam using cativeworks prem.600

[tejano]

hi i don,t know if this receiver is like the cw800 but you may want to enable just enter on remote f1 the ooo

[cisco123]

need to list your settings.your dish might have moved a little.

[fordman01]

hit f1000 on the remote that might help like rodolfa said
patch enable on the screen

[dirtywill2001]

have you given the keys time to roll?

[bbeals]

patch is enabled and I have 70% and 85% quality ???

[bbeals]

left it on the 110 channel for over 5minutes

[dirtywill2001]

tune to channel 200 (cnn) for a couple min. let the keys roll over.

[bigevil69]

go into system settings and make sure autoroll is on

[dirtywill2001]

i guess you gave it time...never tried ch 110 though...

[fordman01]

did you set it to SID?

[bbeals]

tried still no picture or sound???

[bigevil69]

go into installation-antenna setting
top line is sat name put on echostar 7
look just above the signal meter and see what sat name is there

[bbeals]

Its set there remember Bell 91 works great

[bigevil69]

if it does not say found echostar 7 at the bottom when the top one is set for echostar 7 then you are not pointed right
post your dish types and lnb types and setup
remember 1 lnb 1 sat

[bbeals]

Thanks my disc switch is not working as I put 110 right to reciever and I have a picture.

[fordman01]

Originally Posted by bbeals

tried still no picture or sound???

do a factory default on it then rescan the satalites just write down your setting 1st

and dont forget to f1000 after the rescan

menu
system setting
system
channel no. SID
exit out

menu
system setting
OSD
auto roll on

put it on channel for about 10 mins